0 replace the holder, Y close the lid, 5 load the batteries into ' the holder – Nikon SPEEDLIGHT SB-16 User Manual
Page 12: And -) terminals match the diagrams on the holder
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5 Load the batteries into
' the holder.
Load four 1.5V AA-type penlight
alkaline-manganese cells or 1.2V
rechargeable NiCd batteries into the
holder, making sure that the positive
and negative (
+
and -) terminals
match the diagrams on the holder.
Notes:
1)
Use of manganese batteries is not recom
mended
because
their
power
is
insufficient
for operating the SB-16 at full capacity.
2)
Do not mix brands or types of batteries. Also,
avoid
mixing
new
and
old
batteries
since
proper performance will not be obtained.
0 Replace the holder.
' First, make sure the power switch
@ of the flash unit is at the “off”
position; then put the holder back
into the chamber, so that the slots at
both sides of the holder are aligned
with the guide rails inside the battery
chamber.
y Close the lid.
' While applying pressure to the
battery holder with your finger, slide
the lid as far as it will go until it clicks
into place.