HP 49g Graphing Calculator - Manual (Page 80)

Plot setup parameters
Type
ili.
EQ
Iiidep
Connect
Simult
H-Tick
V-Tick
Pixels
The angle imits field indicates the units in which angular
arguments are inteipreted: degrees, radians, or gradians.
The equation(s) you want to plot. It defaults to the
equations listed on the Plot - Polar screen but it can be
changed on the Plot Setup input form.
The name of the independent variable (usually 0 for polar
plots).
Wlien checked—which is the default setting—the plotted
points are connected to fonn a line or curve; when
unchecked, only the plotted points are displayed.
When checked, each equation listed on the Plot - Polar
input fonn is plotted simultaneously; when imchecked—
which is the default setting—one equation is plotted fully
before the next equation is plotted.
The number of imits (or pixels) between tick marks on
the horizontal axis. The default is one tick every 10 pixels.
Whether units or pixels is used depends on the setting in
the Pixels field (see below).
This field is only available if you have chosen to display
axes. Press (F4) to include or exclude axes.
The nmnber of pixels or units between tick marks on the
vertical axis. The default is one tick every 10 pixels.
Wlrether imits or pixels is used depends on the setting in
the Pixels field (see below).
This field is only available if you have chosen to display
axes. Press ® to include or exclude axes.
When checked—which is the default—the values in the
H-Tick and V-Tick fields are intei-preted as pixels. Wlien
unchecked, these values are interpreted as units.
This field is only available if you have chosen to display
axes. Press ® to include or exclude axes.
The type of plot (in this case, polar).
Page 4-12 Plotting graphs