Sony SPP-A5000 - Manual (Page 17)

Installing a charged battery pack
After you have fully charged a battery pack in the base unit, install it
in the cordless handset as follows.
I
■
If the lid con es off, you can
replace it easily by snapping it
ito place.
1 Slide open the battery compartment lid.
2
Remove the charged battery pack from the base
unit and insert it into the handset's battery
compartment.
Press the lever on the base unit's charging compartment
to release the battery pack.
3
Replace the battery compartment lid.
Notes on charging------------------------------------------
• The battery pack supplied uses a unique lead acid battery which
works best when recharged often. Unlike nickel-cadmium
batteries, you do not need to wait until the battery becomes
weak to recharge.
• Avoid leaving the handset without charging the battery for an
extended period of time so that the battery runs down
completely. This can shorten the battery's life. If this happens,
recharge the battery. You may need to charge the battery
several times before it is recharged to its full capacity.
• When charging a battery pack which is completely discharged,
the battery lamps may not light up for a while (10 minutes or
less). There is nothing wrong with your telephone. Continue
charging.
Setting up 11