Troubleshooting – Sony PLM-S700 User Manual

Page 46

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

...

Troubleshooting

If you have any questions or problems not listed below, contact your Sony de. or i; cal
authorized Sony service facility.

Symptom

Cause

Remedy

The picture does not

appear.

Connections are incorrect.

Connect the eqi .em _orrectly

(pages 15 to 20

The signal is not input.

Select the cor mput (page 31).

The Glasstron enters power save

mode.

Put the Gla.s s on again to bring
the forehea ir to the POWER

SAVING Si. JR (page 14).

When you connect to a notebook

type PC, the display mode is set to
local display mode (LCD panel of

your notebook PC).

Change the Display mode. For
details, refer to the instruction

manual of your PC.

The picture is dark or

dim.

You are not wearing the Glasstron
correctly.

Put on the Glasstron correctly (pages
21 and 22).

—

Adjust the brightness with the

BRIGHT control (page 32).

—

Adjust the RGB signal
synchronization (page 39).

The inside window (where the
picture is displayed) is dirty.

Clean the display unit with a soft,
dry cloth.

The picture suddenly

disappears

A warning was displayed for more

than two minutes. (The Glasstron
turned off automatically.)

You continued using the Glasstron

for six hours. (The Glasstron turns
off automahcally after six hours to
prevent eye fatigue.)

The battery pack or battenes are
dead.

Charge the battery pack or replace with
new batteries (page 41).

You put off the Glasstron while the

POWER SAVE is set to ON.

Put the Glasstron on again to bring
the forehead near to the POWER

SAVING SENSOR (page 14).

The picture has no sound.
The sound is noisy.

—

Adjust the volume with the VOL
control (page 32).

The volume does not
become louder.

The AVLS function is on.

Set AVLS in the menu to OFF (page

38).

The equipments are not connected

propely.

Connect the equipments correctly

(pages 15 to 20).

Sound volume of the connected
computer is inappropriate.

Adjust the volume on the computer.

The battery pack

discharges quickly.

The battery pack is not charged

enough.
The battery pack is completely dead

Charge the battery pack fully or use a

new one (page 41).