Sony PLM-S700 - Manual (Page 30)

'iS?sC' ■
Using the Glasstron
You need to set a password the first time you use the Glasstron or after you reset the Glasstron.
Set the password following the procedure in "Setting the password" (pages 28 ana
Before you start... ^
Be sure to follow the procedures in "Connecting the Glasstron" (pages 15 to 20) an. Wearing
the Glasstron" (page 21).
Turn on the Glasstron using the POWER switch, then press PUSH
DISPLAY jog dial.
Change the display language before Screen
pressing the jog dial, if necessary.
DISPLAY LANGUAGE
KHBBKW
FRANÇAIS
CaSEL -a EXEC
If you have set the Glasstron to operate without a password, go to step 3.
Turn the PUSH DISPLAY jog dial to enter the first number of your
password, then press the jog dial. Enter the second and third
numbers in the same way.
ENTER THE THIRD NUMBER
OF YOUR PASSWORD.
I»123«l
Ca SEL • a EXEC
Entered password
If you enter a wrong password, the
message shown on the right appears.
Enter the correct password.
If you have entered a wrong password
more than five times, after about ten
seconds, the Glasstron turns off
automatically.
INCORRECT PASSWORD.
ENTER THE FIRST NUMBER
AGAIN.
:a
SEL
-a
exec
INCORRECT PASSWORD.
SEETHE USER’S MANUAL
30-' US