Sony CCD-TR9 - Manual (Page 69)

Trouble Check
If any difficulty should arise during operation, go through the following table. Should the difficulty
persist, disconnect the power source and contact your Sony dealer or local authorized Sony service
facility.
Symptom Cause
Corrective Actions
Refer to the pages Indicated in
the circle.
Page
The power does not turn on.
The battery is not attached. Attach the battery. •
The battery is dead. Use a charged battry. •
The AC power adaptor is not
connected a wall outlet.
Connect the adaptor to a wall
outlet.
•
CHARGEATTR of the AC power
adaptor is set to CHARGE or
OFF.
Set CHARGEAn’R to VTR.
•
The power goes off.
While being operated In the
CAMERA mode, the camcorder
has been in the pause mode for
more than S minutes.
Turn STANDBY to LOCK at
once and turn it to STANDBY
again.
•
The battery is dead. Use a charged battery. •
The battery pack is quickly
discharged.
The ambient temperature is too
low.
— •
The battery pack has not been
charged fully.
Charge the battery pack again. •
The battery pack is completely
dead, and cannot be recharged.
Use another battery pack. •
START/STOP does not operate.
The tape is stuck to the drum.
Remove the cassette with the
cassete eject button.
•
The tape has run out.
Rewind the tape or use a new
one.
—
POWER is set to VTR. Set it to CAMERA. •
The tab on the cassette is out
(red).
Use a new tape or slide the tab. •
The cassette cannot be
removed from the compartment.
The battery is dead.
Use a charged battery or the
AC power adaptor.
O.«
No function except for cassette
ejection works.
Moisture condensation has
occurred.
Remove the cassette and leave
the camcorder at least an hour.
•
The tape does not move when
a tape transport button is
pressed.
POWER is set to CAMERA or
OFF.
Set it to VTR. •
The tape has run out.
Rewind the tape or use a new
one.
The autofocusing function does
not work.
The AUTO LOCK cover is not
closed tightly
Close the AUTO LOCK
cover.
Shooting conditions are not
suitable for autofocusing
operation.
Open the AUTO LOCK cover
and press FOCUS to adjust the
focus manually.
•
The image on the viewfinder
screen is not clear.
The viewfinder lens is not
adjusted.
Adjust the viewfinder lens.
•
(To be continued)
Chapter 4: Additional Information
69