Tomei Powered FUEL RAIL - Manual (Page 17)

17
REMOVING THE STOCK PARTS
CAUTION
■ Work with minimal amount of gasoline in the tank.
■ Use high-pressure air to clean any dust and debris before removing any parts.
■ Drain all remaining gasoline from the piping, remove the drain hose. Use the pan
and rage to catch any spillages.
■ Use duct tape to block/cover any holes to prevent anything from entering the
engine after removing parts.
(1) Remove all gasoline from the fuel lines.
① Remove the fuel pump fuse.
R32 (Drivers side feet) R33 (Inside the trunk)
② Start the engine.
③ After the engine stalls, crank the engine 3-4 more times to use all gasoline.
④ After turning the ignition off, disconnect the negative battery terminal.
⑤ Disconnect the injector connectors.
⑥ Remove the
vacuum hose
Injector
Damper
(R33 only) ⑦ Remove the
fuel pipe
Fuel filter