Nut tightening, Caution, Oil pan & oil pan baffle machining – Tomei Powered MAIN STUD LADDER SET User Manual
Page 9

NUT TIGHTENING
① Coat the surface of the supplied nuts and the
threads with the supplied grease.
② Tighten the nuts in numerical order as
shown on the left.
(1) Tighten to 4.87~5.25kg,m
(47.8~51.5N・m)
(2) Tighten to 6.5~7.0kgm
(63.7~68.6N・m)
(3) Completely loosen them
in the reverse order.
(4) Tighten to 4.87~5.25kg,m
(47.8~51.5N・m)
(5) Tighten to 6.5~7.0kgm
(63.7~68.6N・m)
CAUTION
Due to certain differences if some blocks,
you may not have enough space for the nut.
In such cases, if needed, then just tighten
the nut without a washer.
⑧
④
②
⑥
⑩
⑨
⑤
①
③
⑦
12 Face Nut
Meting Face
Thread
Front
9
OIL PAN & OIL PAN BAFFLE MACHINING
※When using the Crank Cap Ladders
When using the Crank Cap Ladders, there's a
possibility that there will be interference with the
Oil Pan. The clearance between the No.5 Ladder
and the Oil Pan Baffle is at times extremely
narrow, or may touch.
To have the appropriate clearance between the
No.5 Ladder and the Oil Pan, you may need to
make some modifications/adjustments to the
Oil Pan & Baffle.
Check the 5th Ladder's clearance.
Front
9