Cabletron Systems STHI - Manual (Page 48)

The SNMP Traps Screen
Page 5-13
5.5 The SNMP Traps Screen
Access the System Level screen (Figure 5-6) from the Device Setup menu.
Figure 5-6. SNMP Traps Screen
The SNMP Traps screen is used to provide the STHI with the IP addresses
of remote management stations intended to receive SNMP traps, and to
provide those stations with the community names they will need to access
the STHI with SNMP requests.
5.5.1 Trap Destination
Use these fields to set an IP Address for each workstation designated to
receive trap alarms from the STHI.
5.5.2 Trap Community Name
SNMP protocol requires that all traps issued include an SNMP community
name. This field holds the community name to be sent to the
corresponding network device. Some network management systems
make use of this community name when polling the STHI.
5.5.3 Enable Traps
Setting the value in this toggle field to YES enables the STHI to send SNMP
trap messages to the corresponding device; NO disables the same.
STHI LOCAL MANAGEMENT Flash Image Version: 1.00.00
SNMP TRAPS
Trap Destination Trap Community Name Enable Traps
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
0.0.0.0 N
SAVE RETURN