Dell Adamo XPS (Late 2009) - Manual (Page 41)

16. Lift the system board at an angle towards the side of the computer and out of the computer base.
Replacing the System Board
1. Follow the instructions in Before You Begin .
2. Place the system board on the computer base.
3. Replace the two screws that secure the system board to the computer base.
4. Connect the following cables to their corresponding connectors on the system board:
l thermal fan cable
l display cable
l left I/O board cable
l battery power cable
l AC adapter power cable
l right I/O board cable
5. Route the antenna cables and tape them in place if required.
1 thermal fan cable connector 2 display cable connector
3 left I/O board cable connector 4 battery power cable connector
5 AC adapter power cable connector 6 right I/O board cable connector
7 screws (2)