Replacing the display assembly – Dell Adamo XPS (Late 2009) User Manual
Page 19

10.
Slide and lift the computer base away from the display assembly.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the computer base in position and replace the two screws that secure the display assembly to the computer base.
3.
Route the antenna cables and tape them in place if required.
4.
Connect the following cables to their corresponding connectors on the system board:
l
display cable
l
left I/O board cable
l
battery power cable
l
AC adapter power cable
l
right I/O board cable
5.
Replace the Bluetooth™ card (see
Replacing the Bluetooth Card
).
6.
Replace the WLAN card (see
Replacing the WLAN Card
).
7.
Replace the palm rest assembly (see
Replacing the Palm Rest Assembly
).
8.
Replace the computer battery (see
Replacing the Computer Battery
).
Back to Contents Page
1
screws (2)
NOTE:
Remove the service tag panel if you are replacing the display assembly (see
Removing the Service Tag Panel
).
NOTE:
Replace the service tag panel if you are replacing the display assembly (see
Replacing the Service Tag Panel
).
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.