Dell PowerEdge RAID Controller H800 - Manual (Page 149)

Troubleshooting 149
Driver does not auto-build into
new kernel after customer updates.
This error is a generic issue for Dynamic Kernel
Module Support (DKMS) and applies to all
DKMS-enabled driver packages. This issue
occurs when you perform the following steps:
1 Install a DKMS-enabled driver package.
2 Run up2date or a similar tool to upgrade the
kernel to the latest version.
3 Reboot to the new kernel.
The driver running in the new kernel is the
native driver of the new kernel. The driver
package you installed previously in the new
kernel does not take effect in the new kernel.
Perform the following procedure to make the
driver auto-build into the new kernel:
1 Type:
dkms build -m -v
-k version>
2 Type:
dkms install -m -
v -k version>
3 Type the following to check whether the driver
is successfully installed in the new kernel:
DKMS
The following details appear:
, version>, :
installed
Table 9-7. Linux Operating System Errors (continued)
Error Message Corrective Action
PERC7.2_UG.book Page 149 Thursday, March 3, 2011 2:14 PM