Dell PowerEdge M605 - Manual (Page 69)

About Your System
69
DIMMs must be
populated in
sequential order
beginning with
slot 1. The
following DIMM is
electrically
isolated: DIMM x .
The specified DIMM is
inaccessible to the system
due to its location.
DIMMs must be
populated in sequential
order, beginning with
slot 1. Populate two, four, or eight
DIMMs sequentially.
DIMM pairs must be
matched in size,
speed, and
technology. The
following DIMM
pair is
mismatched: DIMM x
and DIMM y.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated memory
modules. Ensure that all pairs of
memory modules are of the
same type and size, and that
they are properly installed.
See "System Memory" on
page 105. See
"Troubleshooting Blade
Memory" on page 191.
Diskette read
failure.
Faulty or improperly
inserted diskette. Replace the diskette.
Drive not ready. Diskette missing or
improperly inserted in
diskette drive. Reinsert or replace the
diskette.
Error: Incorrect
memory
configuration.
DIMMs must be
installed in pairs
of matched memory
size, speed, and
technology.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated memory
modules. Ensure that all pairs of
memory modules are of the
same type and size, and that
they are properly installed.
See "System Memory" on
page 105. If the problem
persists, see
"Troubleshooting Blade
Memory" on page 191.
Error: Incorrect
memory
configuration.
System halted.
Less than 512 MB of
memory installed. Add memory modules to
achieve a configuration
supported by the system.
See "System Memory" on
page 105.
Table 1-18. Blade Messages (continued)
Message Causes Corrective Actions