Enclosure bezel, Removing the enclosure bezel – Dell PowerEdge M605 User Manual
Page 168
168
Installing Enclosure Components
2 Remove the I/O connector cover from the back of the module. See
3 Install the I/O module in the M1000e enclosure.
a
Lift the handle release latch and open the I/O module handle.
b
Slide the module into the enclosure.
c
Close the handle until it snaps securely into place and the module is
fully seated.
4 Connect all cables that must be attached to the I/O module.
See the documentation provided with the I/O module for information
about its cable connections. See the Rack Installation Guide for
information on using the cable enumerators to organize and manage the
cables.
5 A matching fabric mezzanine card must be installed in one or more blades
to support the new I/O module. If necessary, install the mezzanine card(s)
now. See "I/O Module Mezzanine Cards" on page 123.
Enclosure Bezel
Removing the Enclosure Bezel
1 Press the system power switch to turn off the system. See "System Control
2 Rotate the LCD module so that the underside of the module faces
upward. See Figure 4-11.
3 Remove the cable cover and disconnect the ribbon cable from the LCD
module.
4 Remove the eight screws securing the bezel to the enclosure. See