Dell PowerEdge M605 - Manual (Page 148)

148
Installing Blade Components
Hard-Drive Backplane
Follow these steps to remove and replace the hard-drive backplane.
1 Remove the blade. See "Removing a Blade" on page 96.
2 Open the blade. See "Opening the Blade" on page 100.
NOTICE:
If you are removing two hard drives, label them so you can replace them
in their original locations.
NOTICE:
You must remove the hard drives before removing the backplane.
3 Remove the hard drive(s). See "Removing a Hard Drive" on page 143.
4 Lift the latches at each end of the backplane, then lift the backplane from
the blade chassis. See Figure 3-28.