Installing a media card reader – Dell Precision T7400 (Late 2007) User Manual
Page 261
Adding and Replacing Parts
261
b
Install a drive panel insert (see "Replacing a Drive-Panel Insert" on
9 If you are installing another drive in the drive bay, see the appropriate
installation instructions.
10 Reinstall the drive panel (see "Replacing the Drive Panel" on page 249).
11 Replace the computer cover (see "Replacing the Computer Cover" on
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
12 Connect the computer and devices to electrical outlets, and turn them on.
Installing a Media Card Reader
1 Follow the procedures in "Before You Begin" on page 139.
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55
lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid
injury; avoid bending over while lifting. See your
Product Information Guide for
other important safety information.
CAUTION:
The computer stand should be installed at all times to ensure
maximum system stability. Failure to install the stand could result in the computer
tipping over, potentially resulting in bodily injury or damage to the computer.
2 Remove the computer cover (see "Removing the Computer Cover" on
3 Remove the drive panel (see "Removing the Drive Panel" on page 246).
4 If the 3.5-inch drive-panel insert is installed, remove it (see "Removing a
Drive-Panel Insert" on page 247). Otherwise, ensure that the 3.5-inch drive
panel plate is installed.
5 If another device is installed in the drive bay, remove that device (see the
appropriate device removal instructions).
6 If no screws are attached to the Media Card Reader, check the inside of the
drive panel for shoulder screws. Attach screws to the new card reader.