Dell OptiPlex GX150 User Manual
Page 67

Back to Contents Page
Solving Problems: Dell™ OptiPlex™ GX150 System User's Guide
Finding Solutions
This section describes system and software problems, offers corrective actions, describes the utility, and provides system messages and codes.
Before you call Dell for technical assistance, complete the following tasks to help you resolve computer problems:
Read "
About Your Computer
" and "
Safety Information
."
Take the problem-solving action listed in the following table for the component or equipment that is malfunctioning.
Power Problems
Basic Checks:
l
Test the electrical outlet: ensure that the electrical outlet is working by testing it with another device such as a lamp.
l
Connect the computer power cable directly to an electrical outlet: bypass power protection devices, power strips, and extension cords to
verify that the computer turns on.
l
Check for interference: electrical appliances on the same circuit or operating in close proximity to the computer can cause interference.
If the problem still exists after you complete the basic checks, fill out the Diagnostics Checklist as you perform the following steps:
1. Turn off the computer and peripherals, and disconnect them from their electrical outlets.
2. If you are using a surge protector, remove it.
3. Make sure the power cable is firmly connected to the computer, and then verify that the power cable is directly connected to the electrical
Power indicator does not light
Monitor power indicator does not light
No sound
Printer not working
"
Serial or other parallel devices not working
Serial or Parallel Device Problems
"
Mouse not working
"
Keyboard not working
"
Diskette drive or hard drive: indicators not lit, scraping or unusual
noises, no noise
System battery not working
Expansion card errors or malfunction
"
A program locks up
Recover From a Program That Is Not Responding
Computer locks up
Restart a Computer That Is Not Responding
"
Computer gets wet
Computer is dropped or damaged
Repairing a Dropped or Damaged Computer
"
Hardware devices conflict
"
System memory amount is not correct
System board malfunctions
System board is damaged
Resetting a Damaged System Board
"
An error message
A series of beeps on system startup