Dell Latitude 120L User Manual
Page 92
The computer cannot identify the ExpressCard. Reinsert the card or try another card. See
Using ExpressCards
.
Extended memory size has changed —
The amount of memory recorded in NVRAM does not match the memory installed in the computer. Restart the computer. If the error appears again, contact
Dell. See
Technical Assistance
.
The file being copied is too large for the destination drive —
The file that you are trying to copy is too large to fit on the disk, or the disk is too full. Try copying the file to a different disk or use a larger capacity disk.
A filename cannot contain any of the following characters: \ / : * ? " < > | —
Do not use these characters in filenames.
Gate A20 failure —
A memory module may be loose. Reinstall the memory modules and, if necessary, replace them. See
Memory
.
General failure —
The operating system is unable to carry out the command. The message is usually followed by specific information—for example, Printer out of paper. Take
the appropriate action.
Hard-disk drive configuration error —
The computer cannot identify the drive type. Shut down the computer, remove the hard drive (see
Hard Drive
), and boot the computer from a CD. Then shut
down the computer, reinstall the hard drive, and restart the computer. Run the Hard-Disk Drive tests in the Dell Diagnostics. See
Hard-disk drive controller failure 0 —
The hard drive does not respond to commands from the computer. Shut down the computer, remove the hard drive (see
Hard Drive
), and boot the computer
from a CD. Then shut down the computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the Hard-Disk Drive
tests in the Dell Diagnostics. See
.
Hard-disk drive failure —
The hard drive does not respond to commands from the computer. Shut down the computer, remove the hard drive (see
Hard Drive
), and boot the computer
from a CD. Then shut down the computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the Hard-Disk Drive
tests in the Dell Diagnostics. See
.
Hard-disk drive read failure —
The hard drive may be defective. Shut down the computer, remove the hard drive (see
Hard Drive
), and boot the computer from a CD. Then shut down the
computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the Hard-Disk Drive tests in the Dell Diagnostics.
See
Insert bootable media —
The operating system is trying to boot to a nonbootable CD. Insert a bootable CD.
Invalid configuration information-please run System Setup Program —
The system configuration information does not match the hardware configuration. The message is most likely to occur after a memory module is installed.
Correct the appropriate options in the system setup program. See
System Setup Program
.
Keyboard clock line failure —
For external keyboards, check the cable connection. Run the Keyboard Controller test in the Dell Diagnostics. See
.