Dell PowerVault DL2100 - Manual (Page 96)

96
Installing System Components
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
NOTE:
When future NIC functionality is supported, you must replace the original
NIC hardware key (if installed) with a new hardware key.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 Locate the ISCSI_KEY connector on the system board. See Figure 6-2.
4 Insert the NIC hardware key into the connector onto the board. See
Figure 3-12.
Figure 3-12. Removing or Installing the NIC Hardware Key
5 Close the system. See "Closing the System."
1 NIC hardware key 2 ISCSI_KEY connector
1
2