Dell Broadcom NetXtreme Family of Adapters User Manual
Page 224
User Diagnostics in DOS: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/userdiag.htm[9/5/2014 3:45:19 PM]
uxdiag -fnvm
Programs the raw image into NVM.
uxdiag -fump
Specifies the bin file to update UMP firmware.
uxdiag -help
Displays the Broadcom NetXtreme II User Diagnostics (uxdiag) command options.
uxdiag -I num> Specifies the number of iterations to run on the selected tests. uxdiag -idmatch Enables matching of VID, DID, SVID, and SSID from the image file with device IDs. Used only with -fnvm uxdiag -log Logs the test results to a specified log file. uxdiag -mba <1/0> Enables/disables Multiple Boot Agent (MBA) protocol. 1 = Enable 0 = Disable uxdiag -mbap Sets the MBA boot protocol. 0 = PXE 1 = RPL 2 = BOOTP 3 = iSCSI_Boot uxdiag -mbas Sets the MBA/PXE speed. 0 = Auto 1 = 10H 2 = 10F 3 = 100H 4 = 100F 6 = 1000F uxdiag -mbav <1|0> Enables/disables MBA VLAN. 1 = Enable 0 = Disable uxdiag -mbavval Sets MBA VLAN (<65536). uxdiag -mfw <1/0> Enables/disables management firmware. 1 = Enable 0 = Disable uxdiag -t Disables certain groups/tests. uxdiag -T Enables certain groups/tests. uxdiag -ver Displays the version of Broadcom NetXtreme II User Diagnostics (uxdiag) and all installed adapters. uxdiag -wol <1/0> Enables/disables Magic Packet WOL. 1 = Enable 0 = Disable Table 2: uediag Command Options Command Options Description uediag Performs all tests on all Broadcom NetXtreme II adapters in your system. uediag -c Specifies the adapter (device#) to test. Similar to -dev (for backward compatibility). uediag -cof Allows tests to continue after detecting a failure. uediag -dev Forces an upgrade of the image without checking the version. uediag -fbc Specifies the bin file to update the bootcode. uediag -fbc1 Specifies the bin file to update bootcode 1. uediag -fbc2 Specifies the bin file to update bootcode 2. uediag -fl2b Specifies the bin file for L2B firmware. uediag -fib
uediag -F