Dell Precision R5400 (Mid 2008) - Manual (Page 60)

1. Click Start ® Control Panel® Hardware and Sound® Mouse.
2. Adjust the settings as needed.
Windows XP
1. Click Start® Control Panel® Mouse.
2. Adjust the settings as needed.
Reinstall the mouse driver — See the Dell Technology Guide for instructions on manually installing a device driver.
Run the Hardware Troubleshooter — See Hardware Troubleshooter .
Network Problems
Check the network cable connector — Ensure that the network cable is firmly inserted into the network connector on the back of the computer and the
network jack.
Check the network lights on the back of the computer — If the link integrity light is off, no network communication is occurring. Replace the network cable.
Restart the computer and log on to the network again
Check your network settings — Contact your network administrator or the person who set up your network to verify that your network settings are correct
and that the network is functioning.
Run the Hardware Troubleshooter — See Hardware Troubleshooter .
Power Problems
If the power light is green and the computer is not responding — See Diagnostic Lights .
If the power light is blinking green — The computer is in standby mode. Press a key on the keyboard, move the mouse, or press the power button to resume
normal operation.
If the power light is off — The computer is either turned off or is not receiving power.
l Reseat the power cable in the power connector on the back of the computer and the electrical outlet.
l Bypass power strips, power extension cables, and other power protection devices to verify that the computer turns on properly.
l Ensure that any power strips being used are plugged into an electrical outlet and are turned on.
l Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
l Ensure that the main power cable and control panel cable are securely connected to the system board.
If the power light is blinking amber — The computer is receiving electrical power, but an internal power problem may exist.
Ensure that all components and cables are properly installed and securely connected to the system board.
If the power light is steady amber — A device may be malfunctioning or incorrectly installed.
l Remove and then reinstall all memory modules (see System Memory ).
l Remove and then reinstall any expansion cards, including graphics cards (see Expansion Cards ).
Eliminate interference — Some possible causes of interference are:
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at www.dell.com/regulatory_compliance.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at www.dell.com/regulatory_compliance.