Margin top/bottom, Margin left/right – Dell C1765NFW MFP Laser Printer User Manual

Page 244

242

Copying

6 If necessary, customize the copy settings including the number of copies, contrast, and image quality. See "Setting

Copy Options" on page 235.

7 Ensure that Start Copy is highlighted, and then press the

(Start) button to begin copying.

When you are using the document glass and Multiple-Up is set to Auto, or Manual, the display prompts you

for another page. Press the

button to select Yes or No, and then press the

(Set) button.

If you select Yes, press the

button to select Continue or Cancel, and then press the

(Set) button.

Margin Top/Bottom

To specify the top and bottom margins of the copy:

1 Load the document(s) face up with top edge in first into the ADF.

OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Making Copies From the ADF" on page 235 or "Making Copies From

the Document Glass" on page 233.

2 Press the

(Copy) button.

3 Press the

button until Preferences is highlighted, and then press the

(Set) button.

4 Press the

button until Margin Top/Bottom is highlighted, and then press the

(Set) button.

5 Press the

button or enter the desired value using the numeric keypad, and then press the

(Set)

button.

NOTE:

Values marked by an asterisk (

) are the factory default menu settings.

Margin Left/Right

To specify the left and right margins of the copy:

1 Load the document(s) face up with top edge in first into the ADF.

OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Making Copies From the ADF" on page 235 or "Making Copies From

the Document Glass" on page 233.

2 Press the

(Copy) button.

3 Press the

button until Preferences is highlighted, and then press the

(Set) button.

4 Press the

button until Margin Left/Right is highlighted, and then press the

(Set) button.

5 Press the

button or enter the desired value using the numeric keypad, and then press the

(Set)

button.

NOTE:

Values marked by an asterisk (

) are the factory default menu settings.

4 mm*/0.2 inch*

Specify the value in increments of 1 mm/0.1 inch.

Available Range:

0-50 mm/0.0-2.0 inch