Installing a raid controller card, Hot-plug scsi hard drives, Installing a raid – Dell PowerEdge 800 User Manual
Page 75: Controller card, Installing the optional scsi backplane board

11.
Connect the power cable connector P3 to the power connector on the SCSI backplane. See
12.
Connect the baseboard management controller (BMC) inter-IC (I2C) cable to the SCSI backplane. See
13.
Connect the other end of the BMC I2C cable to connector BP_I2C on the system board. See
Figure A
-3
.
14.
Install the SCSI controller card.
See "
Installing an Expansion Card
" in "Installing System Components" for instructions about installing the card.
15.
.
16.
Install the cover. See "
Replacing the Cover
" in "Troubleshooting Your System."
17.
Stand the system upright.
18.
Install the SCSI drives into the hard-drive bay.
19.
Install the bezel. See "
Installing the Bezel
" in "Troubleshooting Your System."
20.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
21.
Install any required SCSI device drivers.
22.
Run the SCSI controllers tests and the hard-drive tests in the system diagnostics. See "
Running the System Diagnostics
."
Installing a RAID Controller Card
See "
Installing an Expansion Card
" in "Installing System Components" for instructions about installing the card.
Back to Contents Page