Dell PowerEdge 800 - Manual (Page 11)

Back to Contents Page
Service-Only Parts Replacement Procedures
Dell™ PowerEdge™ 800 Systems Installation and Troubleshooting Guide
Recommended Tools
Control Panel Assembly
Chassis-Intrusion Switch
System Board
Recommended Tools
You may need the following items to perform the procedures in this section:
l Key to the system keylock
l Wrist grounding strap
l #2 Phillips screwdriver
Control Panel Assembly
Removing the Control Panel Assembly
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See " Removing the Bezel " in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See " Removing the Cover " in "Troubleshooting Your System."
5. Disconnect the control panel assembly cable from the FRONT_PANEL connector on the system board. See Figure A -3 .
6. Using a #2 Phillips screwdriver, remove the two mounting screws that secure the control panel assembly to the chassis. See Figure C -1 .
7. Lift the control panel assembly and its cable away from the system. See Figure C -1 .
Figure C-1. Removing the Control Panel Assembly
Installing the Control Panel Assembly
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.