Dell OptiPlex SX260 - Manual (Page 15)

As an option, you may mount the computer to a vertical or horizontal surface by using a wall-mount bracket. If you have the integrated flat-panel option, the
stand is integrated as part of the total assembly.
Chassis Stand
You may attach the chassis stand to orient your computer vertically. You can also attach the stand to the mounting plate (see " Mounting Plate ") to hang the
computer under a table- or desktop or to securely attach the computer to a horizontal surface.
1. Raise the captive screw and slide the chassis stand slat into one of three mounting slots on the back of the computer.
2. When the stand is in place, tighten the screw.
To remove the chassis stand, loosen and lift the screw. Hold the screw up while sliding the stand out of the slot.
NOTICE: To ensure proper ventilation, do not place your computer vertically on a desktop without using the chassis stand (see " Chassis Stand ").
NOTICE: To ensure proper ventilation, do not block the cooling vents.
1 captive screw
2 chassis stand
3 mounting slot (for vertical position, upright on a desktop)
4 mounting slot (for horizontal position hanging under a desktop)
NOTE: the stand must not be used in the horizontal position on a desktop. Place the computer directly on a desktop.
5 mounting slot (for vertical position, hanging under a surface)