beautypg.com

Isa configuration utility messages, Icu error messages, Isa configuration utility messages t – Dell OptiPlex Gxi User Manual

Page 99: Appendix b, Cu error messages

background image

ISA Configuration Utility Messages

B-1

Appendix B

ISA Configuration Utility Messages

T

he ISA Configuration Utility (ICU) and its Configu-

ration Manager are capable of identifying problems and
alerting you to them. Both utilities can alert you to prob-
lems with card configuration as well as problems that
prevent proper operation of the utility. This appendix
describes each type of message and lists the possible
causes and actions you can take to resolve any problems
indicated by a message. See the following tables to locate
your message and identify any possible corrective
actions.

I

CU Error Messages

The ICU can display a variety of error messages while in
operation. These messages alert you to problems that pre-
vent the ICU from running correctly, as well as informing
you of resource conflicts that prevent the configuration of
various cards in your computer. If you receive a message
from the ICU, see Table B-1 for suggestions on resolving
any problems indicated by the message.

Table B-1. Configuration Utility Messages

Message

Probable Cause

Corrective Action

Out of memory

Memory allocation
failed

Either of these messages can
appear if the system runs out
of memory during your
operation.

Disable any TSR programs or any unneeded
device drivers.

Not enough memory to
run the ICU

This message appears when
you start the ICU if the sys-
tem does not have enough
memory to run the utility.

Can’t open index file.
This file is required
for ICU to run.

The ICU cannot find the
index file for its database.

Make sure to switch to drive A before attempt-
ing to start the utility.

No Configuration Man-
ager.

The device driver needed by
the ICU is corrupted or is
not correctly configured.

Verify that the following device statement
appears in your config.sys file:

device=

drive

:\

directory

\driv-

ers\dos\dwcfgmg.sys

In this statement, drive and directory represent
the drive and directory where the driver resides.
The default is

c:\plugplay

.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.