Dell OptiPlex Gxi - Manual (Page 102)

B-4 Dell OptiPlex GXi Mini Tower Systems Reference and Installation Guide
The ICU detects
a resource conflict
between this card and
conflicting_card. The
conflicting resource
was:
resource.
You added or modified a
card that now requires
a
resource value
already in use by
conflicting_card.
Try each of the following options until the
problem is resolved:
• Modify the card you are adding so that it
uses a different value for
resource . See
“Modifying a Card” in Chapter 3 for
instructions.
• Modify conflicting_card so that it
uses a different value for resource . See
“Modifying a Card” in Chapter 3 for
instructions.
• If conflicting_card is not the sys-
tem board, remove it from the computer.
See “Removing a Card” in Chapter 3 for
instructions.
• Remove all expansion cards from the ICU,
and then add them back one at a time,
beginning with the new card and resolving
resource conflicts as they arise. See
“Removing a Card” and “Adding a Listed
Card” or “Adding an Unlisted Card” in
Chapter 3 for instructions.
• If you cannot resolve the resource conflict
by any of the preceding methods, remove
the new card. If you were modifying an
existing card, reset the modified card to its
previous resource value.
Table B-1. Configuration Utility Messages (continued)
Message Probable Cause Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.