Dell OptiPlex Gxi User Manual
Page 106
B-8
Dell OptiPlex GXi Mini Tower Systems Reference and Installation Guide
WARNING: Could not
configure
Plug and
Play Card Name.
WARNING: Could not
configure PCI device,
ID=
DeviceID.
Failed to configure
Number of Total Count
Plug and Play ISA
devices. Use your sys-
tem’s configuration
utility to resolve
conflicts. Press any
key to continue.
The card(s) mentioned are
not fully configured due to
resource conflicts.
If you have documentation that lists the allow-
able resource values for your Plug and Play or
PCI expansion card, you can use the following
procedure to locate and resolve the resource
conflict.
NOTE: If you do not have documentation list-
ing the allowable resource values, see the
corrective action for these messages on the
following page.
1.
Start the ICU.
Any Plug and Play or PCI expansion cards
that could not be configured should be
marked
config err
on the list of cards in
the ICU window.
2.
Select the System Resources option from
the View menu.
The System Resource Usage dialog box
displays all resources currently used by the
system.
3.
Select one of the resources used by your
Plug and Play or PCI expansion card,
and click the Used By Card button.
The Card Resources Usage dialog box
identifies which device is using the
resource.
4.
Repeat step 3 until you have identified
all conflicting resources and the cards
that use them.
5.
Modify the cards as needed to free the
resources required by the unconfigured
Plug and Play or PCI expansion card.
See “Modifying a Card” in Chapter 3 for
instructions.
Table B-2. Configuration Manager Messages (continued)
Message
Probable Cause
Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.