Canon BP-511 - Manual (Page 12)

12
Quick Guide
Reference page numbers are indicated by ( →✽✽ ) .
Charge the battery pack.
Connect the power cord to the adapter,
then attach the battery. When the charge
lamp stops blinking and stays lit, the battery
is completely charged. A full battery charge
takes approximately 90 minutes. (
→ 22)
1 Insert the battery pack.
Open the battery chamber cover
and slide the battery pack into
position until it locks into place.
Press the cover closed until it
clicks shut. (
→ 24)
2
Focus on the subject.
Look through the viewfinder and place the
AF point over the subject. Then press the
shutter button down halfway to focus. (
→ 29)
● The AF point which achieves focus will flash in red.
● In low-light conditions or backlit daylight
conditions, the built-in flash fires
automatically. (
→ 86)
9 Take the shot.
Press the shutter button down
fully. (
→ 29)
10
Open the CF card slot
cover.
Slide the cover in the direction
shown by the arrow, then open it.
(
→ 28)
5 Insert a CF card
(optional).
After inserting the CF card, close
the cover. (
→ 28)
● Using CF cards made by Canon
is recommended.
6