Compaq Wireless LAN 300 User Manual

Page 57

Installation (Compaq Tru64 UNIX)

PowerStorm 300 AGP and 300/350 PCI Graphics Controllers 6–5

If this is not the path to the kit on your CD-ROM, you may need to search for the
appropriate file on the CD-ROM by looking for the

tar

extension.

6.3.2.2 Unpacking the Kit

This section describes the procedure for unpacking the compressed kit into a directory
structure on your local filesystem. It is assumed that the compressed kit distribution file
exists as

/var/tmp/PS3x0UNIX.tar

Change to the directory where you copied the kit distribution file:

# cd /var/tmp

Use

tar

to unpack the tar file into a directory structure:

# tar xvf PS3x0UNIX.tar

This will create the

PS3x0UNIX

directory and populate it with the kit files.

6.3.2.3 Installing the Kit

This section describes the procedure for installing PowerStorm 300/350 UNIX Graphics
Support. It is assumed that the kit has been obtained and unpacked into the

/var/tmp/PS3x0UNIX/

directory.

Ensure that the system in which you wish to install PowerStorm 300/350 UNIX
Graphics Support does not already contain a DIGITAL Open3D kit.

To determine if DIGITAL Open3D subsets are installed on the system, enter the
command:

# setld -i | grep O3D | grep installed

If any of these subsets are installed, you must de-install them using the

setld -d

command. For example, to remove the OpenGL support files, you would enter:

# setld -d O3DDWSGLBASE491

Make sure that you are in the directory where you unpacked the kit:

# cd /var/tmp/PS3x0UNIX/

Start the installation.

Start the installation by entering the

setld

command with the

-l

(load) function,

specifying the current directory as the location of the kit:

# setld -l .

Specify the subsets you wish to install.

The installation procedure displays the list of subsets available for installation and
prompts you to choose the desired subsets.

*** Enter subset selections ***