Compaq Wireless LAN 300 - Manual (Page 30)

Installation (Windows NT)
4–4 PowerStorm 300 AGP and 300/350 PCI Graphics Controllers
7. Grasp the top edge of the graphics controller and carefully insert it into the slot, then
firmly seat it.
8. Secure the retaining bracket.
9. Replace the workstation cover.
10. Ensure that the monitor cable is connected to the video output connector located on
the back of the graphics controller.
11. Reconnect the power cord, and restart your workstation.
4.3 Software Installation
This section describes the installation of the Microsoft Windows NT version of the
PowerStorm 300 AGP or 300/350 PCI software.
4.3.1 Microsoft Windows NT Software Installation
The PowerStorm 300/350 software is a set of graphics display drivers to provide OpenGL
support to enable you to run the PowerStorm graphics controllers. This section explains
how to install PowerStorm display drivers on a Compaq Professional Workstation running
Windows NT version 4.0.
Keep this document in case you need to reinstall the PowerStorm 300/350 software for any
reason.
If your PowerStorm 300 AGP or 300/350 PCI graphics controller came pre-installed in
your workstation, the display drivers have been pre-installed as well.
4.3.2 PowerStorm 300/350 Software Components
The PowerStorm 300/350 software CD contains 2D drivers and 3D drivers (the Compaq
accelerated OpenGL support). See Table 4-1.
Table 4-1 PowerStorm 300/350 Software Components on the CD
Component Description File Name
GDI display driver pbxgdac.dll
Kernel mode miniport driver pbxgdac.sys
OpenGL driver—client-side file only pbxgdacogl.dll
OpenGL driver—client-side file only (Intel platform only) pbxgdacp30gl.dll
Configuration application pbxgdactab.dll