BMW 525i Sedan 2004 User Manual
Page 71
69
The symbols also indicate the status of the
service requirement display, refer to
page
.
Calling up stored messages on the
Control Display
Using the CHECK button
1.
Press the button longer:
The first stored message is displayed
2.
Briefly press the button:
Another message is displayed each
time the button is briefly pressed.
Using the Control Center
Control Center, for principle details, refer to
page
:
1.
Open the start menu by pressing the
button
2.
Open the menu by pressing the con-
troller
3.
Select "Service" and press the control-
ler
4.
Select "Check Control messages" and
press the controller. The stored mes-
sages appear on the display
5.
Select the desired message and press
the controller.
The display disappears automatically after
a short time.
To close the display immediately:
Select
and press the controller
Displays after completion of trip
Malfunction reports generated during the
trip are shown consecutively when you
switch off the ignition.
If applicable, the message "Parking lamps
on!" appears at the end of a trip when you
open the driver's door.
In addition, a gong sounds:
As long as the display has not disappeared,
you can view the messages again. Press
the CHECK button for approx. 2 seconds. If
several messages are present, you can
continue to press the CHECK button to
view them in succession.
The Check Control function
>
cancels itself automatically after a brief
period
>
can be canceled by again pressing the
CHECK button for approx. 2 seconds.
Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG