Windows, Electric power windows – BMW 525i Sedan 2004 User Manual
Page 35
33
Indicator lamp displays
>
The indicator lamp beneath the interior
mirror flashes continuously: the system
is armed
>
If the indicator lamp flashes during arm-
ing: doors, engine hood or luggage
compartment lid are not properly
closed. Even if you do not close the
alerted area, the system begins to mon-
itor the remaining areas, and the indica-
tor lamp flashes continuously after
approx. 10 seconds. However, the inte-
rior motion sensor is not activated
>
If the indicator lamp goes out on dis-
arming: no manipulation or attempted
intrusions have been detected in the
period since the system was armed
>
If the indicator lamp flashes on disarm-
ing until the key is inserted in the igni-
tion lock, but for approx. 5 minutes at
the most: your vehicle has been manip-
ulated in the meantime.
Following triggering of an alarm, the indica-
tor lamp will flash continuously.
Avoiding unintentional alarms
The tilt alarm sensor and interior motion
sensor may be switched off at the same
time. You can do this to prevent a false
alarm from being triggered in garages with
elevator ramps, for instance, or when the
vehicle is transported by trailer or train:
Lock, i.e. arm twice. Press the
but-
ton on the remote control twice in succes-
sion, refer to page
The indicator lamp lights up briefly and
then flashes continuously. The tilt alarm
sensor and the interior motion sensor are
switched off as long as the system is
armed.
Interior motion sensor
In
order for the interior motion sensor to
function properly, the windows and glass
roof must be completely closed.
However, switch the interior motion sensor
off, refer to Avoiding unintentional alarms, if
>
children or animals are to remain in the
vehicle
>
the windows or glass roof are to remain
open.
Windows
Opening and closing windows
As of ignition key position 1:
>
Press the switch up to the resistance
point:
The window continues to move down-
ward as long as you continue to hold
the switch
>
Briefly press the switch beyond the
resistance point:
The window moves downward auto-
matically. Press the switch again to
stop the opening movement.
You can close the windows in the same
manner by pulling the switch.
After switching off the ignition
You can still operate the windows:
>
In the radio position for a longer time
>
For approx. 1 minute in position 0 or
with the ignition key removed.
Online Edition for Part No. 01 41 0 157 647 - © 07/03 BMW AG