Canon EOS Rebel xsi - Manual (Page 32)

Installing and Removing the Card
32
1 Open the cover.
Set the power switch to <2>.
Check that “Recording...” is not
displayed on the LCD monitor.
Make sure the access lamp is off,
then open the cover.
2 Remove the card.
Gently push in the card, then let go.
The card will stick out.
Pull the card straight out, then close
the cover.
Removing the Card
Access lamp
When the access lamp is lit or blinking, it indicates that the images
are being written to or read by the card, being erased, or data is
being transferred. While the access lamp is lit or blinking, never do
any of the following. Doing so may damage the image data. It may
also damage the card or camera.
• Opening the card slot cover.
• Opening the battery compartment cover.
• Shaking or banging the camera around.
If the card already contains recorded images, the image number might
not start from 0001. (p.110)
Do not touch the card’s contacts with your fingers or metal objects.
If a card-related error message is displayed on the LCD monitor, remove
and reinstall the card. If the error persists, use a different card.
If you can transfer all the images in the card to a personal computer,
transfer all the images and then format the card (p.40). The card may
then return to normal.
H73_01.fm Page 32 Monday, November 12, 2007 3:33 PM