Processor, Removing the processor – Dell OptiPlex 745 User Manual
Page 124
Back to Contents Page
Dell™ OptiPlex™ 745 User's Guide
Processor
Removing the Processor
1.
Follow the procedures in
Before You Begin
.
2.
Loosen the captive screw on each side of the heat sink assembly.
3.
Rotate the heat sink assembly upward, and remove the assembly from the computer.
Lay the heat sink down on its top, with the thermal grease facing upward.
4.
Open the processor cover by sliding the release lever from under the center cover latch on the socket. Then, pull the lever back to release the
processor.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION:
Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient time
to cool before you touch it.
1 heat sink assembly
2 captive screws in housing (2)
NOTICE:
Unless a new heatsink is required for the new processor, reuse the original heat sink assembly when you replace the processor.