Cooper Instruments & Systems DFI 1650 Multi-Channel Digital Force Indicator User Manual
Page 46
CF 126
43
Nov 2001
Usage
"#aaccRR
↵"
# is the 'pound' or 'hash' character (ASCII decimal 35).
aa is the two-character instrument address.
cc is the two-character channel number
↵ is the 'carriage return' character (ASCII decimal 13).
Example
"#0001RR
↵"
Reply
A text string such as
084-1169-01 01
Remarks
This is the part number and version of the firmware used by the channel's
microprocessor.
RT/WT
Read/write Front Panel Switch Operation
Purpose
Reads or writes the operation the front panel switches when the Protection jumper is
installed.
Usage
"#aaccRT
↵" to read, "#aaccWTn↵" to write.
# is the 'pound' or 'hash' character (ASCII decimal 35).
aa is the two-character instrument address.
cc is the two-character channel number.
n is the argument defined below.
↵ is the 'carriage return' character (ASCII decimal 13).
Argument
The argument is created by adding together the values of the ""0 desired options as
shown.
[VALUE] Value [CLEAR] Value
ENABLED 0. ENABLED 0.
DISABLED 8. DISABLED 4.
[CHANNEL] Value [TARE] Value
ENABLED 0. ENABLED 0.
DISABLED 2. DISABLED 1.
Example
It is desired to disable the [TARE] button for channel 02 when the Protection jumper is
installed. Sending "#0002WT1
↵" will accomplish this.
Reply
When writing: "OK" or "ERROR".
When reading: an ASCll-floating-point value described above
Remarks
If a disabled front panel button is pressed, the message "PROTECTED" will appear on
the display.
RU/WU
Read/write Frequency Response Value
Purpose
Reads or writes the channel's "FREQ. RESPONSE" menu item
Usage
"#aaccRU
↵" to read, "#aaccWUn↵" to write.
# is the 'pound' or 'hash' character (ASCII decimal 35).
aa is the two-character instrument address.
cc is the two-character channel number
n is the frequency response in Hz.
↵ is the 'carriage return' character (ASCII decimal 13 ).
Example
"#0001WU10
↵"
Reply
When writing: "OK" or "ERROR".
When reading: an ASCll-floating-point value.
Chapter 11 Relay Output Channel Commands
11.1 Introduction
These commands affect the operation of Relay Output channels.