Bio-Rad C1000 Touch™ Thermal Cycler - Manual (Page 7)

C1000 Touch TM Thermal Cycler Manual
vi
device” under 47 CFR 15.103(c), in regard to the cited FCC regulations in effect at the
time of manufacture
• Note regarding Canadian EMC compliance: Le present appareil numerique n’emet
pas de bruits radioelectrique depassant les limites applicables aux appareils numeriques
de class A prescrites dans le reglement sur le brouillage radioelectrique edicte par le
Ministere des Communications du Canada
• Cables. Shielded cables must be used with this unit to ensure compliance with the Class
A FCC limits
Battery
The C1000 Touch thermal cycler uses a 3 V lithium-metal coin cell battery and a 4.8 V nickel-
metal hydride rechargeable battery pack to maintain time settings and run data in the event of
AC power loss. If the time and/or run data do not remain set after the unit is turned off, it may
be an indication that the batteries are getting weak. If this occurs, contact Bio-Rad Technical
Support (See “Bio-Rad Laboratories Resources” on page ii.) for assistance.
WARNING! Do not attempt to change the batteries. Contact Bio-Rad technical
support.
F OR THE S TATE OF C ALIFORNIA , USA ONLY
Perchlorate material – special handling may apply, see www.dtsc.ca.gov/hazardouswaste/
perchlorate.
Perchlorate material – lithium battery contains perchlorate.