Great Plains TSF660 Operator Manual - Manual (Page 35)

9/1/2009 500-644M
33 Operating Instructions
Refer to Figures 14 and 15
1. Remove the jack from the transport position
and move to the parking position.
2. If the ground is soft, place a board or plate un-
der the jack to widen the ground contact area.
3. Extend the jack until the weight of the tongue
is off the tractor drawbar and is supported by
the jack.
4. Unplug the hydraulic lines from the hydraulic
pump.
5. Remove the hitch pin and safety chain from
the tractor drawbar.
NOTE: Refer to “Hitching Tractor to Spray-
er,” on Page 15, when you are preparing to
hitch the sprayer to the tractor.
NOTE: If the sprayer is being hitched up and
operated for the first time, it is important to fol-
low the safety, set up, adjustment, and operat-
ing information in the front of this manual
23316
Figure 14
Jack In Parking Position
13811
Figure 15
Jack In Transport Position