ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 8)

5 Beamforming Microphone Array
TOOLS REQUIRED
The following tools are required for installation of the Beamforming Microphone Array.
DROP-CEILING MOUNTING PROCEDURE
Use the following dimensions and orientation for the Suspension Column ceiling tile cut-out for the
drop-ceiling mounted Beamforming Microphone Array:
Drywall saw for cutting
hole in solid ceiling,
Hex wrenches:
3/32 and 9/64.
#1 Phillips
screwdriver.
razor knife for cutting
hole in suspended
ceiling tile.
or
1-1/2"
3" 1-1/2"
1-1/2" DROP CEILING CUT-OUT
SOLID CEILING
CUT-OUT
If ceiling tile is 2’ x 4’,
then this dimension
must be oriented
with the 4’ side. .
If ceiling tile is 2’ x 4’, then this dimension
must be oriented with the 2’ side.
Orientation does not matter with a 2’ x 2’
tile as long as it is square.