ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 14)

11 Beamforming Microphone Array
Slide Beamforming Microphone
Array UP & OVER Keyhole Slots
(E-bus and PoE Cables
Not Shown)
HE
Install fourth screw and tighten all screws.
Use #1 Phillips screwdriver bit to avoid damaging screws.
Route the E-bus and PoE cables under the Mic Mounting Plate to the ends where they will be
connected, then Slide the Beamforming Microphone Array onto the Mic Mounting Plate with the
screws passing through the slotted keyholes.
Insert the final holding-screw through the Mic Mounting Plate into the Beamforming Microphone
Array. Tighten all screws. Plug in and route the cables through the cable slots and secure them
under the Cable Retention Clips provided with the Beamforming Microphone Array.
The following illustrations show this in both lengthwise and rotated mountings relative to the
Suspension Post.
Notice that the Mic Mounting Plate has four holes used for mounting to the back of the Beamforming
Microphone Array. There are three slotted keyholes big enough for screw heads to pass through
and one hole that is not slotted. Partially insert screws into the Beamforming Microphone Array
corresponding to the slotted keyholes in the Mic Mounting Plate.
HE 3X
Cable Retention Clips
NOTE: ONLY INSERT
SCREWS PARTIALLY
Use #1 Phillips screwdriver bit
to avoid damaging screws.