ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 24)

21 Beamforming Microphone Array
For mountings with the cables coming in front of the wall, hold the Beamforming Microphone Array
with the Mic Mounting Plate attached, route PoE cable under the Mic Mounting Plate and the LINK
IN and LINK OUT (if needed) cables to the ends where they will be connected. Connect the LINK
IN, LINK OUT and PoE cables and secure the cables under the Cable Retention Clips as shown
below.
Move the Beamforming Microphone Array forward onto the Wall Mounting Plate with the studs
passing through the slotted keyholes. Then slide the assembly down slightly to firmly seat the studs
into the tops of the slots. If the cables are outside of the wall, carefully route them to the mixer to
avoid tangling or hazard.
Use slotted keyholes in Mic Mounting Plate
to hang Beamforming Microphone Array
on Wall Mounting Plate
LINK IN and LINK OUT
Connectors
PoE Connector
Pass LINK IN, LINK OUT and PoE
cables under Cable Retention Clips
and carefully route behind the
Beamforming Microphone Array
to mixer.
Carefully route cables to the
mixer to avoid tangling or hazard.