ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 20)

17 Beamforming Microphone Array
Chapter 3: Wall Mount Installation
Once you have verified all the firmware updates and necessary connections made while executing
the tasks outlined in the Beamforming Microphone Array Quick-Start Guide, you can proceed to the
actual installation of the Beamforming Microphone Array using the Wall Mounting Kit.
PARTS RECEIVED
The following parts are delivered with the Wall Mounting Kit and will be used for installation of the
Beamforming Microphone Array.
A
QTY 4
Requires #1
Phillips Screwdriver Bit
C
QTY 1
Mic Mounting Plate
B
QTY 1
Wall Mounting Plate
Drywall saw for cutting
hole in wall for cable
passage
#1 Phillips
screwdriver
Verify that you have all the parts required to complete your installation.
When you open the shipping package(s) for the first time, please check that all items purchased
are included. If any of the items (according to your customer order) are missing or damaged,
contact your ClearOne distributor immediately.
TOOLS REQUIRED
The following tools may be required for Wall Mount installation of the Beamforming Microphone
Array. You will also need other tools for installing fasteners (not included in the kit) to hold the Wall
Mounting Plate to the wall where the Beamforming Microphone Array is to be installed.
Level used to
level the Wall
Mounting Plate
Drill bits
appropriate to
fastener type
Electric or
portable drill
Wall fasteners are not provided
and must be appropriate to the
wall material