ClearOne Beamforming Microphone Array Installation Guide User Manual
Page 17
Chapter 2: Ceiling Mount Installation 14
Slide the Trim Plate onto the bottom of the Suspension Column. This must be done before fastening
the Mic Mounting Plate. The Trim Plate will later be positioned to cover the Ceiling Plate when the
unit is fastened to the ceiling.
Sliding the Trim Plate down
may loosen the friction pads.
If the Trim Plate must be slid
down, ensure the friction
pads are firmly pressed
down before proceeding.
Suspension Column
B
Trim Plate
C
Use the screws to fasten the Mic Mounting Plate to the bottom of the Suspension Column.
D
4X
Mic Mounting Plate
HA
Use #1 Phillips screwdriver bit
to avoid damaging screws.
Suspension Column
B