ClearOne Beamforming Microphone Array Installation Guide - Manual (Page 18)

15 Beamforming Microphone Array
Pass the E-bus cables for LINK IN and LINK OUT (if needed), and the PoE cable from above the
ceiling through the pass-through hole, down the Suspension Column and out of the assembly.
Fasten the assembly to the ceiling using four fastening screws (not supplied).
E-bus Cables for
LINK IN and LINK OUT
Connections
PoE Cable
PoE Cable
E-bus Cables for
LINK IN and LINK OUT
Connections
Notice that the Mic Mounting Plate has four holes used for mounting to the back of the Beamforming
Microphone Array. There are three slotted keyholes big enough for screw heads to pass through
and one hole that is not slotted. Partially insert screws into the Beamforming Microphone Array
corresponding to the slotted keyholes in the Mic Mounting Plate.
Move the Trim Plate up the Spanner Post and snug it against the Ceiling Plate. The friction pads in
the Trim Plate will hold it in position on the Spanner Post.