SARGENT AL - Alarmed Exit - Manual (Page 6)

Sample Wiring #4 – TL- Prefix (SARGuide) with Solenoid Exit Trim
(ET) and 3532 Power Supply and Battery Back-up
SARGuide is always powered. During a power outage SARGuide remains illuminated by 3532 battery back-up
power. The 3532 power supply also provides battery back-up power to the solenoid exit trim (ET), which is used to
control access.
Notes:
1. Pigtail harness, raceway and electric
hinge 8-pin connector terminations
and wire colors all match.
2. Typical raceway locations shown.
Location may vary depending on
door type.
3. 4 to 8-pin patch cable converts
TL- 4-pin connector pins 1 & 2 to
8-pin connector pins 1 & 2.
4. Wire to pigtail harness assembly as
shown. Then plug pigtail connector
into hinge connector.
F. TL- SARGuide Wiring Examples cont’d
6
2, Red (773-6 ET)
1, Black (773-6 ET)
2, Red (+)
1, Black (-)
TL- SARGuide
80 Series Rail
with 4-pin connector
4 to 8-pin
patch cable
Electric hinge #1 with
8-pin connectors
Raceway harness #1 with
8 & 4-pin connectors.
The 4-pin connectors are not
used here
Pigtail harness #1
assembly with
8-pin connector
1 7 5
6 4
3
2 8
EXIT EXIT EX
IT
2, Red (TL +24)
1, Black (TL
-
24)
120 VAC
L/N/G
L N
Input
120VAC 60HZ
+ - + -
Output
1
Output
2
1 2 3 4 5 6 7 8 9
TB1
TB2
TB3
+
-
Battery Battery
3532
24VDC, 2Amp
Power Supply
w/Battery Backup
GND
24VDC
773,774, 775 or 776
Solenoid ET with
8-pin connector.
Plug into raceway connector.
1 7 5
6 4
3
2 8
C
NO
NC
Switch or
relay contacts
*
Typical wiring to fail secure ET shown.
Refer to 773-6 ET instructions for wiring
requirements, specifications, etc.
Pigtail harness #2
assembly with
8-pin connector
Raceway harness #2 with
8 & 4-pin connectors.
The 4-pin connectors are not
shown or used here.
Electric Hinge #2 with
8-pin connectors
Copyright © 2009, SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7711C - 5-1-9