SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 12)

Section 3: DTD Mode Data Transfer Device Operating Instructions
Section 3: DTD Mode
From the factory, the DTD is set in DTD Mode. This mode is used to send data and retrieve transaction event logs from controllers
that support two way communications.
When the DTD is first powered-up the the Start-up Screen is displayed (refer section 1.3). To access the DTD menu system press
the ENTER key, which is the number 5 key in the center (refer to figure 1 on page 3).
Next you are presented with the DTD Mode Main Menu: IMPORT/EXPORT, UTILITIES and STATUS. The IMPORT/EXPORT
menu is used to export data to the controller or import transaction logs. The UTILITIES menu contains options to retrieve information
from the door controller, time and date options and communications options. The STATUS menu contains door information, DTD
information, as well as an option to change the operating mode. These menu options are described in more detail in later sections.
To navigate through the menu system, press the down arrow, which is the number 8 key in the lower center or the up arrow, which is
the number 2 key in the upper center. The blinking cursor on the left of the DTD display moves up and down next to the various
options. To select and option press the ENTER key. To move back to a previous menu press the left arrow, which is the number 4 key
on the left center.
Page 12 of 26 Corbin Russwin # FM 296; Sargent # A7973B Rev. 1.1
Note: If at any time you want to return to the Start-up Screen press the * key in the lower left corner. Also
pressing the left arrow brings you back to the previous menu.
Note: If you need to change the mode to Printer Mode, please refer to section 3.3 and 3.3.3.