Tweco Cigweld WeldSkill Auto Darkening Welding Helmets - Manual (Page 9)

WeldSkill Auto-Darkening Welding Helmets
8 February 29, 2012
SECTION 2: Introduction
2.01 How to Use This Manual
This Owner’s Manual usually applies to just the underlined
specification or part numbers listed on page ii. If none are
underlined, they are all covered by this manual.
To ensure safe operation, read the entire manual, including
the chapter on safety instructions and warnings.
Throughout this manual, the word WARNING,
CAUTION and NOTE may appear. Pay particular attention to
the in formation provided under these headings. These
special annotations are easily recognized as follows:
WARNING
Gives information regarding possible personal injury.
Warnings will be enclosed in a box such as this.
CAUTION
Refers to possible equipment damage. Cautions will
be shown in bold type.
NOTE
Offers helpful information concerning certain operating
procedures. Notes will be shown in italics.
2.02 Equipment Identification
The product identification number is printed on the outer
shipping carton. Record this number for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there is
any damage, notify the carrier immediately to file a claim.
Furnish complete information concerning damage claims or
shipping errors to:
CIGWELD, Customer Care Department, 71 Gower St,
Preston, Victoria, Australia, 3072.
Include all equipment identification numbers as described
above along with a full description of the parts in error.
Additional copies of this manual may be purchased by
contacting CIGWELD, Customer Care Department, at the
address given above. Include the Owner’s Manual number
and equipment identification numbers.
SECTION 3: General Information
3.01 WeldSkill Auto-Darkening Welding Helmet.
The WeldSkill Auto-Darkening Welding Helmet is a product manufactured specifically for welding comfort, versatility,
performance and fume deflection. Seven models are available in the WeldSkill range: An Auto-Darkening Fixed Shade
11 Version, Part Number 454304 (Black) and six Auto-Darkening Variable Shade 9-13 Version, Part Number 454305
(Blue), Part Number 454314 (Carbon Fibre Graphic), Part Number 454321 (Racer), Part Number 454322 (Tribal),
Part Number 454323 (White Carbon), Part Number 454324 (Oz Flag). To ensure your complete satisfaction with your
new WeldSkill Auto-Darkening Welding Helmet and to realise a safer work environment, we ask that you read the
following Operating Manual thoroughly before use.
3.02 User Responsibility
This product will perform as per the information contained herein when installed, operated, maintained and repaired in
accordance with the instructions provided. This equipment must be checked periodically. Defective equipment
should not be used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced
immediately. Should such repairs or replacements become necessary, it is recommended that such repairs be carried
out by appropriately qualified persons approved by CIGWELD. Advice in this regard can be obtained by contacting an
accredited CIGWELD Distributor.
This product or any of its parts should not be altered from standard specification without prior written approval of
CIGWELD. The user of this product shall have the sole responsibility for any malfunction which results from
improper use or unauthorised modification from standard specification, faulty maintenance, damage or improper
repair by anyone other than appropriately qualified persons approved by CIGWELD.