Tweco Cigweld WeldSkill Auto Darkening Welding Helmets - Manual (Page 17)

WeldSkill Auto-Darkening Welding Helmets
16 February 29, 2012
1. Mode Switch: The Mode Switch is used to change the Filter Lens between Welding and Grinding modes. Note that
additional eye and face protection is recommended when Grinding.
2. Delay Switch: The Delay Switch is used to adjust the hold time of the Filter lens after welding is completed. Manually adjust
delay time to desired level as required for application.
3. Sensitivity Control: The Sensitivity Control is used to make the Filter Lens more responsive to different light levels.
Manually adjust the sensitivity level as required for the application.
4. Variable Shade Control: The Variable Shade Control is used to adjust the Shade level between 9-13. Manually adjust shade
to desired level as required for the application.
SECTION 10: Routine Maintenance & Inspection
This equipment must be checked periodically. Defective equipment should not be used. Parts that are broken, missing,
plainly worn, distorted or contaminated, should be replaced immediately. Should such repairs or replacements become
necessary, it is recommended that such repairs be carried out by appropriately qualified persons approved by CIGWELD.
Advice in this regard can be obtained by contacting an accredited CIGWELD Distributor.
NOTE
Inspect lenses frequently. Immediately replace any scratched, cracked, or pitted lenses as they may impair visibility
and reduce protection.
Inspect Helmet Shell and Harness Assembly frequently. Immediately replace any damaged or worn components.
The Internal Battery is not replaceable. Do not attempt to open the Filter Lens.
10.01 Cleaning the WeldSkill Auto-Darkening Welding Helmet
WARNING
When cleaning the Welding Helmet or Filter Lens Do Not use solvents or abrasive cleaning agents.
In order to ensure the continued safe and reliable operation of your WeldSkill Auto-Darkening Welding Helmet it should be cleaned
with a soft, clean lint-free cloth after use.
NOTE
Keep the Sensors and the Solar Cell clean at all times.