beautypg.com

Weldskill auto-darkening welding helmets – Tweco Cigweld WeldSkill Auto Darkening Welding Helmets User Manual

Page 19

background image

WeldSkill Auto-Darkening Welding Helmets

18

February 29, 2012

SECTION 12: Basic Troubleshooting

FAULT

CAUSE

REMEDY

1. The Filter Lens does not

operate.

A.

B.

The Internal Battery is discharged.

Filter Lens is faulty.

A.

B.

The Internal Battery is not replaceable.
Do not attempt to open the filter lens.

Replace the Filter Lens.

2. The Filter Lens flickers or does

not darken.

A.

B.

Front Cover Lens is dirty or
damaged.

Sensors are obstructed.

A.

B.

Clean Cover Lens with a soft cloth.
Replace if necessary.

Clean the Sensors with a soft cloth.

3. Filter Lens stays dark after the

weld is extinguished or the Filter
Lens is dark when no arc is
present.

A.

B.

C.

Sensors are obstructed.

Sensitivity and or Delay Switch not
set correctly.

Ambient light level is too bright.

A.

B.

C.

Clean the Sensors with a soft cloth.

Adjust the Sensitivity and or Delay
Switch accordingly.

Reduce the ambient light level in the
area.

4. The centre of the Filter Lens

viewing area appears darker
than the sides of the Filter Lens
viewing area.

A. This is a normal characteristic of the

LCD Lens.

A. Keep the viewing angle from the object

being welded as close as possible to
90 degrees.

WARNING

If the above troubleshooting recommendations do not resolve the problem, do not use the Auto-Darkening
Welding Helmet. Contact Cigweld for further information.