Tweco 141i Fabricator - Manual (Page 26)

Fabricator 141i
INTRODUCTION 2-2 Manual 0-5145
2.06 User Responsibility
This equipment will perform as per the information contained herein when installed, operated, maintained and
repaired in accordance with the instructions provided. This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used. Parts that are broken, missing, plainly worn, distorted
or contaminated, should be replaced immediately. Should such repairs or replacements become necessary, it is
recommended that such repairs be carried out by appropriately qualified persons approved by Tweco. Advice in
this regard can be obtained by contacting an Accredited Tweco Distributor.
This equipment or any of its parts should not be altered from standard specification without prior written approval
of Tweco. The user of this equipment shall have the sole responsibility for any malfunction which results from
improper use or unauthorized modification from standard specification, faulty maintenance, damage or improper
repair by anyone other than appropriately qualified persons approved by Tweco.
2.07 Fabricator 141i Portable System Package (Part No. W1003141)
Art # A-11575_AD
• Fabricator 141i Power Source
•
140 Amp MIG Gun
• Victor Argon Regulator/Flowmeter & Hose
• Tweco Electrode Holder & Ground Clamp
• Drive Rolls & Contact Tips
• Sample Electrodes & Shoulder Strap
• 20A to 15A Power Cord Adapter
• Operator Manual & CD
Comes Complete With